MAHR - Шариковые направляющие Marmotion - 2010 Английский язык

       для размещения заказа - mahr@mahr-tools.ru

-      18 M a r M o t i o n . H i g h - p re c i s i o n ro t a r y s t ro k e b e a r i n g s

 Mahr

Closed Guide Bush with Stop Rings

N 552

       Suitability

       Design as for N 550, with stop rings fixed on both sides.
       • When used in combination with shaft diameter dw ISO-h3, preloading of the rotary

        stroke bearings is guaranteed.
       • The stop rings ensure the cage is effectively restricted for linear and rotary movements.
       • Smooth running of the rotary stroke bearing is not impaired by the stop rings.

       Features

       • Stop rings fixed on both sides.
       • The closed guide bush and integrated ball cage form a separate component.
       • Guide bore diameter d1 is finely honed to ISO tolerance IT 3, Rz 0.5 – 1.5 m

        depending on diameter.
       • Roundness within 1/3 ISO-IT 3.
       • Cylindricity within IT 1.
       • Radial run-out of a shaft inserted under preloading is within 0.0005 mm.
       • Outside diameter dB n4 with radial run-out error within IT 4, ground to guide bore

        diameter d1, lead-in taper on one side.
       • The maximum stroke path Hmax is determined from the length of guide bush l3 and the

        length of the ball cage l2: Hmax = 2 (l3-l2).
       • See page 37-41 for instructions on installation and servicing.

       Material

       • Special roller bearing steel 100 Cr 6 (1.2067 or 1.3505)
       • Carefully heat-treated, hardness rating HRC 60–64/HV 720–815
       • Steel stop rings

       Special designs

       Other dimensions or designs based on workpiece drawings are available.
       These can also be produced using stainless steel (1.4112).

       Order Information

       Rotary stroke bearing consisting of:

       Guide bush N 552/dw/d1/l1                                                                Order No. 5003 . . .
       Ball cage N 501/dw/d1/l2                                                                 Order No. 50010 . .
       or

       Ball cage N 500/dw/d1/l2                                                                 Order No. 50000 . .

                                   mahr@mahr-tools.ru
                                    www.mahr-tools.ru